Using The Tool; Fig. 26 - Black and Decker Fire Storm FSNS100 Manual De Instrucciones

639224-00 FSNS100 Stapl

USING THE TOOL

Complete all steps of PREPARING THE TOOL before using the tool.
This tool is shipped from the factory with a "single sequential actuation" trigger. To
fire, grip the tool firmly to maintain control, position nose of tool onto work
surface, push the tool firmly against work surface to depress safety (S) Fig. 28,
and squeeze trigger to fire a nail. Allow tool to recoil away from work surface as nail
is driven. This "single sequential actuation" method provides the most accurate
fastener placement.
Disconnect tool from air supply before performing
maintenance, clearing a jammed fastener, leaving work area, moving tool to
another location, or handing the tool to another person.
Clean and inspect tool daily. Carefully check for proper operation of trigger and
safety mechanism. Do Not use the tool unless both the trigger and the safety
mechanism are functional, or if the tool is leaking air or needs any other repair.
The depth to which a nail is driven is controlled by the depth adjustment knob (A) Fig.
29. The depth of drive is factory adjusted to a nominal setting. Test fire a fastener and
check depth. If a change is desired, rotate the adjustment knob (A) Fig. 29. The
adjustment knob has detents every
increase the depth of drive, rotate the knob counterclockwise to decrease the depth of
drive. Test fire another fastener and check depth. Repeat as necessary to achieve
desired results. The amount of air pressure required will vary depending on the size of
the fastener and the material being fastened. Experiment with the air pressure setting to
determine the lowest setting that will consistently perform the job at hand. Air pressure
in excess of that required can cause premature wear and/or damage to the tool.
12/14/05 7:25 AM Page 8
A

Fig. 26

OPERATING INSTRUCTIONS
Fig. 28
1
/4 turn. Rotate the knob (A) Fig. 29 clockwise to
8
A Fig. 27
S