Load Label Roll In Rewind Mode - Carl Valentin Spectra Serie Instrucciones Abreviadas Y Recomendaciones De Seguridad

Spectra

Load Label Roll in Rewind Mode

In rewind mode the labels are wound up internally after printing for later use.
•
Open the printer cover.
•
Open the printhead (A) by turning the red pressure lever (B) anticlockwise.
Spectra 216: Pull the centring plate (K) outwardly.
•
Remove the outside label mounting plate (C).
•
Load the label roll with inner winding onto the unwinding roll (D) and attach again the label mounting plate.
•
Lead the label material below the label guiding (E).
Pay attention that the label runs through the photocell (F).
•
Place the labels around the front sheet (G) and lead them below the mechanics to the rear.
•
Clamp the label material, with the handle (H) designated for it, at the rewinding roll (I).
Spectra 216: Lift the centring plate (K) again upwards.
•
In order to move the printhead (A) down, turn the red pressure lever (B) in clockwise direction until it locks.
•
Adjust the adjusting rings (J) of the label guiding to the width of material.
•
Close the printer cover.
86 English