Clean The Print Roller; Clean The Printhead; Clean The Label Photocell - Carl Valentin Spectra Serie Instrucciones Abreviadas Y Recomendaciones De Seguridad

Clean the Print Roller

A soiled print roller can lead to a reduced print quality and can affect the transport of material.
CAUTION!
Print roller can be damaged!

Do not use sharp or hard objects to clean the print roller.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove the labels and transfer ribbon from the label printer.
•
Remove the deposits with the roller cleaner and a soft cloth.
•
If the roller appears damaged, replace it.

Clean the Printhead

Printing can cause accumulation of dirt at the printhead e.g. by colour particles of the transfer ribbon, and therefore it is
necessary to clean the printhead in regular periods depending on operating hours, environmental effects such as dust etc.
CAUTION!
Printhead can be damaged!

Do not use sharp or hard objects to clean the printhead.

Do not touch the protective glass layer of the printhead.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove the labels and transfer ribbon from the label printer.
•
Clean the printhead surface with a special cleaning pen or a cotton swab dipped in pure alcohol.
•
Before using the label printer, let the printhead dry for about two to three minutes.

Clean the Label Photocell

CAUTION!
Label photocell can be damaged!

Do not use sharp or hard objects or solvents to clean the label photocell.
The label photocell can be soiled with paper dust. This may affect the label scanning.
•
Turn the lever counter clockwise to lift up the printhead.
•
Remove the labels and transfer ribbon from the label printer.
•
Blow out the photocell (A) with the compressed air spray. You have strictly to observe the instructions mentioned on the
can.
•
Moisten a cleaning card (B) with printhead and roll solvent to clean additionally the photocell inside.
•
Reload the labels and transfer ribbon.
English
Spectra
99