Setting Up The Playard; Important; Configuring The Bassinet - Evenflo BabySuite Manual De Instrucciones

SETTING UP THE PLAYARD

1
B
A
C
D
2
F
E
3
4
G
H
I
I
2
IMPORTANT: Make sure you ALWAYS install the feet and
wheel assemblies BEFORE setting up the playard.
Remove feet and wheel assemblies
A
bag. Discard bag.
Slide two wheel assemblies onto both wheel
B
bases C , as shown, until they snap into place with
an audible click.
Install two feet A onto both foot bases
until they snap into place with an audible click.
Remove the playard from the carry bag. Unhook the two Velcro ® tabs
to remove the mattress pad .
F
Separate the corners to open the playard.
Note: Do not push center of the floor down yet.
WARNING
To prevent injury or death, DO NOT allow child in product with
SIDES DOWN. ALWAYS make sure sides are raised and all four
rails are fully and securely locked by firmly pushing down on
the center of each rail.
Lift up both long top rails until they securely lock into place.
G
Note: The floor must stay up, as shown, so the rails will lock properly.
If the rails do not lock into place, pull up on the strap handle
feet together, and try to lock the rails again.
Lift up both short top rails I until they securely lock into place.
5
from plastic
B
D , as shown,
6
E
1
, draw the
H
Remove child and all accessories from the playard.
To remove the mattress pad
Push down on the center of the floor
J
IMPORTANT: NEVER use the playard without the mattress pad securely
installed on either the playard floor or in the bassinet.
To use the playard with the mattress pad alone:
Place mattress pad on the floor of the playard, cushion side up. Insert the
F
six mattress straps K through the slots
them to the Velcro tabs on the underside of the playard floor. Make sure all
F
six straps are properly secured to the playard and the Velcro tabs are facing
downward, securing the pad to the playard floor.
Note: The mattress pad must always be used with the cushion side up.
K
IMPORTANT: NEVER use the playard without the mattress pad securely installed
on either the playard floor or in the bassinet.
A
B
disconnect three mattress straps from each side of the playard, then remove the pad.
A, B
SETTING UP THE PLAYARD
J until it locks into a flat position.
L in the floor of the playard and fasten
K
L

CONFIGURING THE BASSINET

3