Braun 5 Serie Manual Del Usario página 11

4. Remaining shaving time / Shaver must be charged.
5. Time left in the cleaning process.
6. To maintain 100% shaving performance, replace your
foil and cutter block, when the display (16) shows
«replace foil» (after about 18 months) or when the
shaving parts are worn. Change both parts at the
same time for a closer shave with less skin irritation.
(Shaver foil (10) and cutter block (11): 51S)
The display will keep on reminding you during the
next 7 days to replace the shaving parts. Then the
shaver will automatically reset the display.
After you have replaced the shaving parts (foil and
cutter block) push the info key (17) 4 times until the
display shows «reset foil?». Then push the info key for
at least 3 seconds to reset the display.
While doing so, the display blinks. When the reset is
complete the display shows «reset ok». The manual
reset can be done at any time.
7. System has initiated automatic battery maintenance
(it is fully discharging and then recharging the
batteries).
8. Environment temperature not suited for charging.
Allow the shaver to remain for some time at room
temperature for optimal charging conditions.
Best environmental temperature range for charging
is 60 °F to 95 °F / 15 °C to 35 °C.
9. Intensive cleaning needed – return to the
Clean&Renew™ station as soon as possible.
To reset the display, push the info key (17).
10. Display demo: hold the info key (17) for 3 seconds.
11. Info key, press once: duration of last shave.
Press again: total number of shaves (cannot be reset).
Press again: key part number for shaver foil and
cutter block. Press again: foil reset? (can be resetted,
see point 6).
12. No display – shaver is completely discharged.
11