Peavey ICA Serie Guia De Operadores página 59

Rated Power (two channels):
400 watts @ 20 Hz - 20 kHz both
channels driven at < 0.1% THD
Rated Power (one channel):
415 watts @ 1 kHz at < 0.01% THD
Minimum Load Impedance:
ICA 800V-70: 12.5 ohms
ICA 800V-100: 25 ohms
Maximum RMS Voltage Swing:
ICA 800V-70: 85 volts
ICA 800V-100: 110 volts
Frequency Response:
10 Hz - 25 kHz; +0, -.3 dB at 1 watt
Power Bandwidth:
ICA 800V-70:
10 Hz - 100 kHz; +0, -3 dB at rated
power
ICA 800V-100:
10 Hz - 50 kHz; +0, -3 dB at rated
power
THD (two channels driven):
ICA 800V-70:
<0.15% @ 400 W from 20 Hz -
20 kHz with both channels driven
ICA 800V-100:
<0.1% @ 400 W from 20 Hz - 20 kHz
with both channels driven
THD (one channel driven):
<0.008% @ 400 W @ 1 kHz
SMPTE IMD:
<0.1% 60 Hz and 7 kHz, @ 400 W
Slew Rate:
35 V/µs
Due to our efforts for constant improvements, features and specifications are subject to change without notice.
ICA ™ 800V SPECIFICATIONS
Damping Factor:
>400:1 @ 20 Hz - 400 Hz
Input CMRR:
>-65 dB @ 1 kHz
Voltage Gain:
x40 (32 dB)
Input Sensitivity:
ICA 800V-70:
1.77 volts for rated output
ICA 800V-100:
2.5 volts for rated output
Input Impedance:
20 k ohms, balanced
Hum and Noise:
> -108 dB, "A" weighted referenced to
rated power
Crosstalk:
> -65 dB, "A" weighted referenced to
rated power
Current Draw @ 1/8 power:
ICA 800V-70: 765 watts
ICA 800V-100: 775 watts
Current Draw @ 1/3 power:
ICA 800V-70: 1,100 watts
ICA 800V-100: 1,150 watts
Idle Current Draw:
45 watts in Standby Mode
Maximum Current Draw:
ICA 800V-70:
1,680 watts for rated power
ICA 800V-100:
1,700 watts for rated power
59
Thermal Emissions (BTU/hr.):
550 @ 1/8 power,
835 @ 1/3 power
Cooling:
120 mm DC fan, off until heatsinks
reach 45 C, then variable speed
o
Controls:
2 rear panel attenuators, sequential
turn-on / off
Indicator LEDs:
2 Clip, 2 Signal, 2 LFC, 1 Protect,
1 Power
Protection:
Temp., DC, turn-on bursts,
subsonic, incorrect load or short
Connectors:
8-pin plugable signal input, 4-pin
plugable sequential power,
4-terminal barrier strip, IEC AC
power connector
Construction:
All steel; 16 ga. chassis, 18 ga. top,
12 ga. rack ears
Dimensions:
5.25" x 19" x 16.4"
133 mm x 483 mm x 416.6 mm
Gross Weight:
51.4 lbs. (23.3 kg.)
Net Weight:
45 lbs. (20.4 kg.)