Guardian Technologies H7550 Instrucciones De Uso Y Cuidado página 5

DIRECTIONS FOR USE
CONTROL OPERATION
1. Cool/Warm Mist & Night Light Control
Turns night light on/off. Selects cool or warm mist. Water temperature is maintained at room
temperature for cool setting and 80 degrees for warm. Allow 15 minutes for water to
warm. Follow instructions for desired combination. The images show the screen
display for the combination of the cool/warm mist and night light settings.
Default: Night light/Warm mist
control on.
Press 2 Times: Night light ON.
Cool mist ON.
2. Auto Humidistat
This is a preset setting. Press the Auto button to activate the automatic humidity function, then the ideal
humidity of 50% is maintained, including warm mist and night light. When the humidity level in the room is
less than the auto humidity level (50%), the humidifier will continue to produce moisture automatically.
Once the room level is met, the humidi er will turn itself off.
3. Timer
Press the Timer button to determine the operating time, it can be regulated between 1 and 12 hours
or for continuous operation.
E-8
= Warm
= Night Light
Press 1 Time: Night light OFF.
Warm mist ON.
Press 3 Times: Night light OFF.
Cool mist ON.
DIRECTIONS FOR USE
CONTROL OPERATION
4. Adjustable Humidistat
Set the desired humidity in % by pressing the Adjustable Humidistat button. We recommend a relative
humidity of between 40% and 50%. The appliance can be regulated from 40% to 75% in 5% increments.
If the humidity exceeds the desired setting, the appliance will turn itself off. The appliance will not turn itself
off if it has been set for Continuous Operation ("Co"). The desired value is shown while you are making the
selection. After a few seconds, the display automatically switches to the current value. Note: If the room
humidity is below 15% then the display will fash.
%
5. Mist Control
When you press the Mist Control button there are three options:
Press once for LOW. Press twice for MEDIUM.
6. Low/No Water
When it is time to refill, the low water indicator will blink on the display.
7. Safety Mode "OH"
The humidifier is equipped with a thermal safety device that will display "OH" when activated. If it enters a
mode showing "OH" it will automatically restart when cooled down. If the unit does not automatically restart,
then allow the unit to cool and cycle the power button to reset and start the humidifier.
Important:
there may be an abnormal condition and the unit may need
service. Call Customer Service
Press three times for HIGH.
(No Icons will be displayed
for this combination).
If the unit continues to display "OH" or shut down,
E-9