Directions For Use - Guardian Technologies H7550 Instrucciones De Uso Y Cuidado

DIRECTIONS FOR USE

SET UP
Select a firm, level, flat location - at least six inches (15 cm) from any wall or object for proper air flow.
Place the humidifier on a water-resistant surface, as water can damage furniture and some flooring.
Do not place unit directly on carpet, towels, blankets or other absorbent surfaces.
Guardian Technologies will not accept responsibility for damage caused by water spillage.
FILLING -
Make sure unit is unplugged.
1. Separate the tank from the base of the unit.
3. Pour cool, clean water directly into the
tank. Do not pour anything but water
into the tank.
5. Attach the tank to the base of the unit
and plug in.
E-6
2. Flip over water tank and open the tank
lid, turning it to the left.
4. Close the tank lid, turning it to the right.
It is important to FIRMLY secure cap
after filling the tank with water.
6. Extension Wands
If desired, assemble extension wands by
fitting ends together. Then attach to the
humidity spout. The wands will extend the
mist to a higher level in the air to help disperse
throughout the room.
DIRECTIONS FOR USE
7. Power button
Before turning on make sure there is water
in the unit. Press the Power button.
%
9. Water Level Window & Auto Shut Off Feature
The tank includes a water level window so you can
easily see when it is time to re ll with water. The unit
will automatically shut off and a low water icon will
blink on the display panel if the water level is too low.
If this happens, unplug the unit, remove the tank
and refill.
%
8. Select Desired Settings
See"Control Operation" section for available
unit functions. Note: When you power "on" the
humidistat reading range is from 15% to 90%.
If the room humidity is below 15%, the display
reading will flash.
E-7