Scott Procap Instrucciones De Uso página 40

40
 Fix eventually removed face seal.
 Place the wiper in its groove.
 Place the face shield in the carriages and secure with screws.
Wheel carriage
 Remove the face shield from the helmet's wheel carriages.
 Remove the carriages from the slide bars, sliding them from front to back.
 Slide in new carriages and push them against the brow seal.
 Prior to mounting the face shield, check that the wiper is in its groove. Place
the face shield in the carriages and secure with screws.
Welding shield
o Removal and mounting of the welding shield is done in the same manner as the main visor.
o Welding filters are fitted from the back of the flip-up frame (fenestra) and retained by a spring
clip. The spring clip can be detached and hinged outwards by pressing upwards and outwards
from the bottom
• Fit always an anti-spatter lens (064497) in front of the welding filter to
protect it from sparks.
• Fit the welding filter. Then, if desired, fit a further anti-spatter lens behind
the welding filter (compulsory if the welding filter is made of glass).
• Put the retaining clip back into its recess at the bottom.
• A further anti-spatter lens can be fixed in the frame of the welding shield, to protect the main
visor (e.g. grinding)
Helmet
Brow seal
 Loosen the screws of the brow seal (4 pcs) and remove it.
 Set a new seal into place. When the edge groove of the seal grips the teeth in the shell, the
screw holes will come aligned.
 First screw in the two outermost screws, then the ones in the middle.
Headband
 Remove the brow seal.
 Lift the headband fasteners (anchors) (4 pcs) from the notches inside the shell.
 Slot a new headband into place. Check that the anchors are pressed down to the bottom of the
notches.
 Fix the brow seal.
Airduct
 If needed, remove the headband.
 Remove the airduct.
 Place the splitted end of a new airduct into place by stuffing the two outermost flaps in the hose
socket and letting the broad flap stay out.
 Insert the other end right under the brow seal.
 Press the edges of the airduct carefully in the shell groove to eliminate any leaks.
 Slot eventually removed headband back into place. Check that the anchors are pressed down to
the bottom of the notches.
* * * * * * *