Specification; Pin Allocation Of Balance Output Plug D-Sub25P - KERN FEJ-A07 Manual De Instalación

2 Specification

2.1 Pin allocation of balance output plug D-SUB25P

PIN Signal
1 1. Limit (LOW)
2 1. Limit (LOW)
3 1. Limit (LOW)
4 2. Limit (OK)
5 2. Limit (OK)
6 2. Limit (OK)
7 3. Limit (HIGH)
8 3. Limit (HIGH)
9 3. Limit (HIGH)
10 4. Limit
11 4. Limit
12 4. Limit
13 5. Limit
14 5. Limit
15 5. Limit
16 ERR
17 ERR
18 ERR
19 During measure-
ment
20 During measure-
ment
21 During measure-
ment
22 Audio signal
23 Audio signal
24 External signal (+)
25 External signal (-)
12
Input/
Output
NO Output ON, when first limit (LOW) is reached
NC Output OFF, when first limit (LOW) is reached
COM - Joint contact first limit (LOW)
NO Output ON, when second limit (OK) is reached
NC Output OFF, when second limit (OK) is reached
COM - Joint contact second limit (OK)
NO Output ON, when third limit (HIGH) is reached
NC Output OFF, when third limit (HIGH) is reached
COM - Joint contact third limit (HIGH)
NO Output ON, when forth limit is reached
NC Output OFF, when forth limit is reached
COM - Joint contact forth limit
NO Output ON, when fifth limit is reached
NC Output OFF, when fifth limit is reached
COM - Joint contact fifth limit
NO Output ON in case of error message
NC Output OFF in case of error message
COM - ERR joint contact
NO Output ON, if measured quantity is 5 times
greater than reading range
NC Output OFF, if measured quantity is 5 times
greater than reading range
COM - Joint contact during measurement
NO Output On for audio signal
COM - Joint contact when audio signal is given
Input Contact for output control (+)
Input Contact for output control (-)
Function
FEJ-A07-IA-defsi-0610