Install Door Panels - Jennair JS42NXFXDE Guía Para La Instalación

Install Door Panels

IMPORTANT: Use the foam packaging to prop and hold the
door(s) open while installing a door panel.
1. Align the two shoulder washers, on the back of the door panel,
with the "J" slots on the side of the refrigerator door. Slide the
panel onto the door.
A
A. Shoulder washer and hex head pointed screw
B. "J" pocket
2. Lower the panel bracket down onto the adjustment pins at the
top of the door.
A. Door panel
B. Mounting bracket
3. Repeat steps 1 through 2 to install the second door panel.
B
A B
C
C. Adjustment pins
4. Using slotted hex-head screws (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator and freezer doors, to the respective
door panels. Do not fully tighten the screw.
A
A. Bottom hinge
Install Top Grille Panel
B
A. Top grille panel
B. Cabinet sides
Standard Integrated Grille Installation—Flush Grille
1. Hook the panel brackets onto the mounting bolts extending
from the top of the refrigerator.
A. Panel brackets
B. Grill trim piece
2. Pull the grille panel down slightly to lock into place.
Fully Integrated Grille Installation—Full Height Grille
1. Align the bracket on each side of the top grille panel with the
mounting bolts.
2. Push the grille panel forward until the bracket snaps into place.
Door Swing Adjustment
It may be necessary to adjust the swing of the door. Make sure the
refrigerator door(s) can open freely. If the door(s) opens too wide,
install the door stop pin (provided with refrigerator).
1. Hold the door open to a position that is less than 90°.
2. Insert the door stop pin into the top hinge in the hole shown.
B
B. Mounting bracket
A B
A
B
23