Craftsman CMCCSP20 Manual De Instrucciones página 5

To reduce your exposure to these chemicals,
wear approved safety equipment such as dust
masks that are specially designed to filter out
microscopic particles.
Avoid prolonged contact with dust from power
•
sanding, sawing, grinding, drilling, and other
construction activities. Wear protective clothing and
wash exposed areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay on the skin may
promote absorption of harmful chemicals.

WARNING: Use of this tool can generate and/
or disburse dust, which may cause serious and
permanent respiratory or other injury. Always
use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles
away from face and body.

CAUTION: Wear appropriate personal hearing
protection during use. Under some conditions
and duration of use, noise from this product may
contribute to hearing loss.
Before Operating Pole Saw
• For safe operation, read and understand all
instructions before using the pole saw. Follow all
safety instructions. Failure to follow all safety instructions
listed below, can result in serious personal injury.
• Watch what you are doing. Use common sense. Do not
operate pole saw when you are tired.
• Use pole saw for cutting tree branches only. Do not
use pole saw for purposes not intended. Do not use for
cutting other items.
• Only well-instructed adults should operate pole saw.
Never allow children to operate.
Do not allow children or untrained individuals to use
•
this unit.
• Wear the following safety gear when operating pole saw:
ʵ heavy-duty gloves
ʵ steel-toed safety footwear with non-skid soles
ʵ safety glasses, goggles or face screen that are marked
to comply with ANSI Z87
ʵ safety hard hat that is marked to comply with
ANSI Z89.1
ʵ ear mufflers or ear plugs
ʵ face or dust mask (if working in dusty areas)
• Wear heavy long pants and boots. Do not wear
loose fitting clothing, short pants, jewelry of any kind, or
go barefoot.
• Secure long hair so it is above shoulder level to prevent
entanglement in any moving parts.
• Before cutting, always provide the following:
ʵ clear work area
ʵ secure footing
ʵ planned retreat path from falling limbs
• Inspect tree before trimming. Make allowance for
branches to fall freely to the ground.
• Do not use your pole saw to fell saplings.
While Operating Pole Saw

DANGER: To reduce the risk of electric shock
do no use on wet surfaces. Do not expose to rain.
Store indoors.

DANGER: Avoid Unintentional Starting –
with battery installed, don't carry appliance with
with finger on switch. Be sure switch is off when
installing battery.
• Stay alert. Use common sense while operating the unit.
• Keep work area clean. Cluttered areas invite injuries.
• Always remove battery from pole saw when finished
cutting or when left unattended.
• Keep children, animals and bystanders at least 50'
(15 m) away from pole saw. Only pole saw user should be
in work area.
• Do not use the pole saw to cut down trees.
• Do not grasp the exposed saw chain when picking up or
holding the pole saw.
• Grip pole saw securely - one hand on the pole, the other
on the handle.
• Keep finger off trigger until ready to make cut.
• Before starting pole saw, make sure chain is not
touching anything.
• Keep all parts of body away from chain when pole saw
is running.
• Do not force pole saw while cutting. Apply light pressure.
It will do the job better and safer at the rate for which it
was intended.
• Carry pole saw from one place to another:
• with battery removed,
• fingers off/away from trigger,
• by holding pole at balance point, and
• with guide bar and chain to rear and with
scabbard attached.
• Do not cut small brush and saplings with the pole saw.
Slender matter may catch in the chain and be whipped
toward you. This could also pull you off balance.
• Do not operate in poor lighting.
• Keep firm footing and balance. Do not overreach.
Overreaching can result in loss of balance or exposure to
hot surfaces.
• Keep all parts of your body away from any moving part.
• Do not, under any circumstance, use any attachment or
accessory on this product, which was not provided with
the product, or identified as appropriate for use with this
product in this instruction manual.
• Inspect pole saw before each use and after dropping or
other impacts. Ensure there are no significant defects
or damage.
Do Not Operate Pole Saw:
ʵ while under the influence of alcohol, medication,
or drugs.
ʵ in rain or in damp or wet areas.
ʵ where highly flammable liquids or gases are present.
English
3