Troubleshooting; Guarantee And Service; Conformity Declaration - brennenstuhl Jet-Light 2 x 18 W Instrucciones De Uso

Jet-Light 2 x 18 W, FL-18
9 Cleaning
Pull the plug out before cleaning. For safety reasons, clean the equipment with a dry or damp cloth.
Do not use any acid cleaning agents or chemicals (solvents, petroleum spirits, etc.) or rough sponges.
Never submerge the Jet Light FL-18 in water.
10 Disposal
At the end of its life-span, do not dispose of the product with the normal domestic refuse. Enquire
about your local council's policy for disposing of the device in a proper and environmentally-friendly
way.
11 Trouble-shooting
Fault
Jet Light FL-18 does not switch
on
Jet Light FL-18 does not work
IMPORTANT:
All other repairs must be carried out only by a technician.

12 Guarantee and service

This article is guaranteed for 2 years.
Repairs must only be carried out by an authorised dealer.
Damage caused by improper operation, non-observance of the operating instructions are not included
in the guarantee. Also excluded from the guarantee are wearing parts (e.g. light bulbs).
For further information please see our Service/FAQ section at www.brennenstuhl.com

13 Conformity declaration

The CE symbol is used in accordance with the following European Directives:
2006/95/EC Low voltage directive
2004/108/EC Electro-magnetic compatibility Directive
The declaration of conformity is lodged with the manufacturer.
Manufacturer:
Hugo Brennenstuhl GmbH & Co. KG · Seestraße 1-3 · 72074 Tübingen · Germany
H. Brennenstuhl S.A.S. · F-67460 Souffelweyersheim
lectra-t · Blegistrasse 13 · CH-6340 Baar
Operating instructions
Possible cause(s)
- lamp or
- starter is defective
- Electricity supply has been
interrupted or there is not
connection to the mains
Remedy
- Replace lamp or
- starter
- Check correct plug connection
and fuse
Stand: FL-06-2011_K