Included In Delivery; Safety Instructions - brennenstuhl Jet-Light 2 x 18 W Instrucciones De Uso

Jet-Light 2 x 18 W, FL-18
1 Introduction
These operating instructions must be carefully read in full. They are an integral part of your newly
purchased product and contain important information for its operation and use. Always observe all the
safety instructions when using this product. The Jet Light FL-18 is suitable for standing upright,
hanging and laying flat and can be used as a portable light indoors and outside. If you have any
questions about using the Jet Light FL-18, please contact your dealer or our customer service
department. The operating instructions should be kept in a safe place and be passed on to third
parties, if necessary.
2

Included in delivery

1 x lamp including two tubular lamps
1 x stand
1 x handle
2 x feet
2 x screws for the handle
3

Safety instructions

IMPORTANT:
Please note the following information in order to avoid injury or damage.
Operating environment: The Jet Light FL-18 is protected against damp and splashes. Please note,
however, that the device is not waterproof.
DANGER: Non-observance of safety instructions can result in danger to life by electric current.
The guarantee shall be rendered invalid for damage which occurs as a result of not complying with
these operating instructions, especially the usage and safety instructions.
Likewise, the manufacturer shall not be liable for any consequential damage or loss.
- If defects are detected, do not use the Jet Light FL-18.
- Never open the Jet Light FL-18 except to replace the light bulbs. Such interventions can result
in risk of death by electric shock.
- Unauthorized remodeling, manipulation and/or altering the Jet Light FL-18 are not permitted
on safety grounds.
- Never look directly at the light.
- Do not use the Jet Light FL-18 in environments where there is a risk of explosion in which
there are flammable liquids, gases or dust.
- Regularly check the Jet Light FL-18 for damage.
- Disconnect the Jet-Light FL18 from the power supply when changing the tubular lamps. Pull
the plug out of the socket.
- Repairs must be carried out by authorised technicians only.
- Allow the Jet-Light FL-18 to cool down before touching it (e.g. when wishing to change the
light bulb).
- Ensure that there is a distance of at least 0.5 m on all sides from flammable materials
.
- A damaged supply line must be exchanged by customer services or by an authorized
technician only.
Operating instructions
2 x Adjustable screws
2 x Foot screws
2 x Nuts
1 xOperating instruction
Stand: FL-06-2011_K