Information For After-Sales Service - Astralpool ANA01 Manual De Instalación Y De Utilización

14 - List of potential problems
- Not enough reagent or no reagent detected at
all (blinking led).
- Pump latex worn or broken (blinking
- Incoherent measurement or lack of light (
continually on).
- "Chlorine max" led is blinking (above 2.5 mg/l),
production stopped:
unplanned in-leaking of air.
-
led blinks slowly (3 seconds): problem with
flow detector.
If there is an inexplicable problem, put the
machine on "by-pass" by pressing on
seconds, and call your after-sales service (to put
g
the regulator back on normal operations, press
on for 10 seconds).
This "by-pass" position means that the chlorine
production machines must once again be
manually set to fit your pool configuration ----
continuous production.
INFORMATION FOR AFTER-SALES
SERVICE
A --
The error codes
on the screen. They mean that the machine
needs maintenance.
b --
The error codes
information pertaining to a temporary dysfunction
or a problem that does not require immediate
maintenance. The machine is running normally.
These errors do not appear directly in the menu.
They are indicated by a dot on the display screen
8 8 8 8 8 8
.
g
To display this information, it is necessary to
CL
press on + and to roll out the menu indica-
tions if there are several errors.
led).
led
pool de-primed or
g
for 10
are directly displayed
C --
and indicate
A01
Problem with flow
- no water or flow in the analysis chamber.
- pump defective or out of order.
A02
Problem with sensor
- machine open.
A03
Problem with sensor
- diode weak or out of order.
A04
Problem with calculating chlorine
concentration
- inconsistent values.
A06
Injection defect
- no reagent present, or none left.
A07
Reading error
- no flow through the circuit.
b05
Reading error
- unstable measurements,
- air in the circuit,
- sensor disruption.
b09
Warning error
- no salt left (if salt chlorinator),
- electrode scaled-up or defective,
- no chlorine left, if dosage pump or solenoid
valve,
- chlorine pump or solenoid valve defective,
- no electrical power at output from salt board,
- servo-control relay defective.
23
_ _
C
_