Machine Start And Stop; Stopping The Machine; Machine Operation (Scrubbing/Drying) - KENT Razor E17 Instrucciones De Uso

MACHINE START AND STOP

Starting the machine
1. Prepare the machine as shown in the previous paragraph.
2. Drive the machine to the working place by pushing it with the hands on the handlebar (2).
3. Connect the power supply cable (21) to the electrical mains.
WARNING!
Before connecting the power supply cable to the electrical mains, check that frequency and voltage, shown on
the machine serial number plate (1), match the electrical mains voltage.
4. Lower the squeegee (11) with the lever (19).
5. Turn the solution flow control lever (4) to a position between the minimum limit (5a) and maximum limit (5b). In no case it is
possible to close completely the water flow to the brushes during operation.
6. While keeping the hand on the handlebar (2), start the machine by turning the brush/pad-holder switch and the vacuum system
switch (52 and 53) to "I".

Stopping the machine

7. Turn the brush/pad-holder switch and the vacuum system switch (52 and 53) to "0".
8. Disconnect the power supply cable (21) from the electrical mains.
9. Lift the squeegee with the lever (19).
10. Insert the positioning pin (24) and lift the brush/pad-holder by engaging the transport/parking device (23a).

MACHINE OPERATION (SCRUBBING/DRYING)

1. Start the machine as shown in the previous paragraph.
2. While keeping both hands on the handlebar (2), move the machine and start scrubbing/drying the floor.
CAUTION!
To avoid damaging the floor surface, do not use the brushes without the solution and, when the machine is not
operating, stop the brush/pad-holder by pressing the switch (52).
CAUTION!
Before lifting the brush/pad, turn it off by pressing the switch (52).
3. If necessary, adjust the solution quantity by using the lever (4).
NOTE
For correct scrubbing/drying of floors at the sides of the walls, KENT suggests to go near the walls with the right side of
the machine as shown in figure 3.
Machine speed adjustment
4. The machine speed varies according to the type of floor to be cleaned and the choice of using the brush or the pad.
If necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.
A
Razor E17
INSTRUCTIONS FOR USE
Figure 3
909 6311 000(3)2009-11
ENGLISH
B
P100160B
11