Rs Or Pda Power Center - Zodiac Pool Systems Jandy AquaPure Serie Manual De Instalación Y Funcionamiento

3. Remove the white cap covering the comm hole (see Figure 19).
4. Thread the controller cable through the hole. A grommet may be necessary depending on the size of the cable
being used.
5. Attach a cable tie to the controller cable as shown (see Figure 19).
Figure 19. Accessing and Wiring to the Power PCB
6. In the AquaLink ® RS or PDA power center, wire the power pack directly to the LOAD SIDE of the fi lter pump
relay (see Figure 20).
240 VAC
Filter Pump Relay
To Filter Pump
(240 VAC)
Figure 20. Wiring Power Pack to an AquaLink RS or PDA Power Center (240 VAC and 120 VAC)
Comm Hole
AquaLink RS or PDA Power Center
Aux. 3 Relay
To Filter Pump
(120 VAC)
To Power Pack
(240 VAC)
To Breaker
Panel
Cable Tie
120 VAC
Filter Pump Relay Aux. 3 Relay
To Breaker
Panel
Page 15
To Power Pack
(120 VAC)