Parallel Connection - Master audio JOKER Serie Manual Usuario

Master Audio
2.2. Configurations

2.2.1. Parallel connection

Connect the signal (mixing desk output) to INPUT on the first unit. Use the LINK
output to transfer the INPUT signal to the second unit and thus sequentially for further
units. All of the units in this chain must be switched on.
For the mains connection use the cable with the blue Neutrik PowerCon NAC3FCA.
Do not connect Joker series units using PowerCon without earth.
Fig.2. Parallel connection for Joker cabinets
2.2.2 Parallel connection with subwoofer
You can connect the Joker subwoofers in parallel with Joker full range cabinets.
Please, follow the same parameters as explained in figure 2.
3. MOUNTING AND PLACEMENT
For a proper installation of the acoustic cabinet systems, it is strongly recommended
to carefully read the following advices.
3.1. Placement
Fig.3. Flying placement
Joker Series (Active). Version 1.4
The Full Range cabinets should be located in a high
position (between two or three meters), slightly inclined to
the audience. If the loudspeakers are located too low, the
listeners at the end of the room will not hear a good sound
quality.
Jan14
17