Tabla de contenido
Publicidad
1.
Prepare the Site
2x12 Backing Material
Matériau de support 2x12
Listón de refuerzo de 2x12
NOTE: The dimension provided is for a 34-1/2" (87.6 cm) vanity height. If an
alternate height is desired, calculate the desired height of the backing material.
Measure and mark 31" (78.7 cm) up from the floor. This will be the height from
the top of the 2x12 backing material to the floor.
Ensure there are no obstructions in the wall (such as wiring or plumbing) from
the marked height down to the floor. If there are obstructions, select another area
within the site to install the vanity.
Secure 2x12 backing material to the studs with framing nails. The backing material
should span the length of the vanity.
If a lavatory/vessel will be installed: Rough in the water supply and drain lines
into the plumbing cutout area of the vanity. Refer to the lavatory/vessel
roughing-in and the vanity roughing-in for proper placement.
NOTICE: To avoid the risk of product damage, the finished wall must be straight and
plumb, and the floor is flat and perpendicular to the finished wall. If the finished wall
is not straight and plumb, and the floor is flat and perpendicular to the finished wall,
the vanity will not be properly supported and will cause misalignment of the
lavatory and drawers.
Complete the finished wall. Make sure the finished wall is straight and plumb,
and the floor is flat and perpendicular to the finished wall.
Préparer le site
REMARQUE: La dimension fournie est pour une hauteur de meuble de 34-1/2" (87,6
cm). Si une hauteur alternative est désirée, calculer la hauteur désirée du matériau de
renfort.
Mesurer et marquer 31" (78,7 cm) vers le haut à partir du sol. Ceci sera la hauteur
à partir du dessus du matériau de renfort 2x12 au sol.
S'assurer qu'il n'y ait pas d'obstructions dans le mur (telles que câblage ou
plomberie) à partir de la hauteur marquée vers le sol. Si il y a des obstructions,
sélectionner une autre zone sur le site pour installer le meuble.
Sécuriser le matériau de renfort 2x12 aux montants avec des clous de cadrage. Le
matériau de renfort devrait être la longueur du meuble.
Kohler Co.
31" (78.7 cm)
7
1082756-2-A
Publicidad
Tabla de contenido
