Max/Min Funktion - Trotec BS15 Manual De Instrucciones

Direct the noise level meter with the microphone (1) directly towards
the noise source.
To avoid affecting the sound waves hold the measuring device as
far away from your body as possible or place it on a stand. A stand
fastening (6) is on the rear of the casing. Avoid vibrations or move-
ments.
Increase the distance to the object you want to measure, if the
measuring range is exceeded (OVER).
Use the enclosed wind deflector (8) for wind (>10m/s) so as
not to distort the measurement through wind sounds. The wind
deflector does not distort the measurement results.
B - 8

MAX/MIN funktion

For continuous measurements, only the maxima or minima value is
shown on the display. This measurement function makes it easier
for you to determine the peak level. The MAX function is activated by
pressing the MAX-MIN button on the side.
Pressing the switch again switches to the MIN operation and vice versa.
The respective function is shown as „MAX" or „MIN" on the display.
In order to deactivate this measuring function hold the MAX-MIN button
pressed for approximately 2 seconds or turn the measuring device off.
Operating manual – Digital sound level meter
G