E - Troubleshooting Guide - EasyPro LEVPANO 513600 Manual De Instrucciones Y Mantenimiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

-
Keep the winch in good operating condition. Non-serviced mechanical parts can cause operating
problems or even accidents.
3) Maintenance of the head :
The head requires cleaning at intervals.
Keep the pawl pin well greased.
Use a paraffin oil.
E – TROUBLESHOOTING GUIDE
If there is apparently a fault on the EASY PRO LEVPANO
for it to be repaired, taking all necessary safety precautions (wear a helmet, goggles and gloves).
If the device is locked in the raised position, make sure that the plasterboard panel is fixed at the ceiling or
secure this by means of supports, before attempting to unlock it.
DIFFICULTY
Device locked in the raised
position
Comes down freely without
brake
Goes up with difficulty
The device does not lock in
the horizontal position
NOTE :
- If the problem persists, contact the After-Sales Department
- For any spare parts order, refer to the exploded view, page 27.
POSSIBLE CAUSE
- Brake locked
- Cables stuck and/or
damaged
- Columns locked
- Excess winch grease
- Tightening of the brake
- Lock washer inoperative
- Presence of foreign matter
- The pawl remains locked
14
go through the following points before asking
®
CORRECTION
Undo the crank handle and put it
back in contact
Check the passage of the cables
and their condition
Check the cleanness of the
columns
Degrease the lock washer and
the support
Put the crank handle and the
lock washer in contact
Check the condition of the
washer
Clean the device
Clean the pawl pin and grease it
with a paraffin oil

Publicidad

Tabla de contenido
loading

Tabla de contenido