Playcore Swing-N-Slide PB 9242 Instrucciones De Ensamblaje página 16

Assembly Plan
Hammer
3/8'' hole
T-nut
t-nut
Swing
Beam
30mm Wood Screw
Swing Hanger Assembly
1. Tap T-nut into 3/8'' hole as shown in (Step 1).
2. Place a Slotted beam clamp over the swing hanger as shown in (Step 2).
3. Insert the swing hanger into the beam and thread it into the T-nut until it is flush or near flush with the top of the T-nut.
A screwdriver may be used to twist the hanger, as shown in (Step 3).
4. Orient swing hanger as shown in (Step 4). Use (4) 30mm screws to secure beam clamp.
5. Check hanger to ensure it does not spin.
6. Repeat for all swing hangers.
Slotted Beam Clamp
Use Screwdriver to aid in tightening
Swing Hanger
Slotted Beam Clamp
Swing Hanger
(4) 1-1/4'' screws
(4) 30mm screws
16
Fig. 9
CORRECT!