Cleaning And Maintenance; Service Centre - Max 43803 Manual De Instrucciones

Use
Fit a suitable drill or bit for the task. Select
gear, direction and torque.
Start the drill by pressing the on/off button
(8). The more the button is depressed, the
faster the chuck will revolve. The LED work
light (9) comes on and lights up the working
area when you press the on/off button.
Allow the drill to reach full speed before
starting to drill.
Do not press the drill too hard. Select a low
speed for screwing, large drill bits or hard
materials and a higher speed for small drill
bits or softer materials.
Switch off by releasing the on/off button.
Useful tips for drilling
When drilling in smooth surfaces, e.g. tiles,
stick a piece of strong tape on the drilling
point before drilling to prevent the bit
slipping.
Always centre-punch the drilling point � rst
when drilling steel.
Place a piece of scrap wood under the item
when drilling thin sheet metal to avoid
deforming the sheet.
Lubricate the drilling point with oil when
drilling into metal. Use machine oil for steel
and paraffi n oil for aluminium.
To avoid splinters when drilling wood or
plastic, place a piece of scrap wood under
the item or drill from both sides.
Use a high speed drill bit when drilling
plastic.
For large holes, start with a small diameter
drill and then move up to the desired
diameter.

Cleaning and maintenance

Clean the drill with a slightly damp cloth or
compressed air after use and always keep all
surfaces and ventilation slots free from dust.
Never use corrosive or abrasive cleaning
agents, as they may attack the plastic parts
of the drill.

Service centre

Note: Please quote the product model
number in connection with all inquiries.
The model number is shown on the front of
this manual and on the product rating plate.
For:
• Complaints
• Replacements parts
• Returns
• Guarantee issues
• www.schou.com
GB
27