About This Guide; Unpacking The Product; Product Overview - D-Link NetDefend DFL-1660 Guia De Instalacion

About This Guide

This guide contains step-by-step instructions
for setting up the D-Link DFL-1660 Firewall.
Please note that the model you have purchased
may appear slightly different from those shown
in the illustrations.

Unpacking the Product

Open the shipping carton and carefully unpack
its contents. Please consult the packing list
located in following information to make sure all
items are present and undamaged. If any item
is missing or damaged, please contact your
local D-Link reseller for replacement.
- One (1) DFL-1660 NetDefend UTM Firewall
- One (1) Power Cord
- One (1) Console Cable
- One (1) Ethernet Cable
- One (1) Ethernet Cable
- One (1) Reference CD
(Contains documentation in PDF format)
- Two (2) Rack Mounting Brackets
- One (1) 12-Month IPS Subscription
- One (1) 12-Month Anti-Virus Subscription

Product Overview

Front Panel - DFL-1660
F
Figure 1. DFL-1660 Front Panel
Item Feature Description
A LCD Panel Used to display status and operation
messages.
B Keypad These keys are used in conjunction with
the messages on the LCD Panel.
C LEDs Power LED (top): Indicates that the
NetDefend UTM firewall is powered on.
System LED (bottom): Indicates the
system status of the NetDefend UTM
firewall
D Console Port Used to access the NetDefendOS
Command Line Interface (CLI) via
RS-232 Cable.
E USB Ports (2) Reserved for future use.
F 10/100/1000Mbps The assigned numbers for the ports are
Ethernet Ports* 1 to 6 (from left to right).
Table 1. DFL-1660 Front Panel Descriptions
2  D-Link NetDefend Firewall
(RS232)
(CAT5 UTP/Straight-through)
(CAT5 UTP/ Cross Over)
C A
E D B
* Configurable Gigabit Ethernet ports with autosensing
duplex and auto MDI/MDIX. When configuring one of the
ports, reference the interface name that corresponds to
the location of the port. For the default interface name
bindings for each Ethernet port, see Table 2 "Default
Interface Assignment".
DFL-1660 Default Interface Settings
Interface Interface
Port Name Type IP Address
1 WAN1 DHCP 0.0.0.0/0
Client
2 WAN2 Static IP 192.168.120.254/24 Disable
3 DMZ Static IP 172.17.100.254/24
192.168.10.1/24
4 LAN1 Static IP
5 LAN2 Static IP 192.168.20.1/24
6 LAN3 Static IP 192.168.30.1/24
Table 2. Default Interface Assignment
Note: D-Link NetDefend Firewalls only allow
Web GUI access from the LAN1 port by default
for security reasons. That means the Web GUI
access is only allowed on port No. 4 of front
plate by default for DFL-1660.
Device Status LEDs and Ethernet Port LEDs
Link
Speed
Figure 2. Ethernet
RJ-45 Port LEDs
The device LEDs show information about current
device status. When the device is powered
up, the POWER LED changes from off to solid
green and the SYSTEM LED changes from off
to solid green. Startup takes approximately one
minute to complete. The Ethernet LEDs show
the status of each Ethernet port. Table 3 lists
the name, color, status, and description of each
device LED.
Note: If you would like to turn the device off and
on again, we recommend waiting a few seconds
between shutting it down and powering it back on.
Web-Based
Mgmt
Disable
Disable
Enabled
Disable
Disable
TX/RX
Status