Initial Configuration - D-Link NetDefend DFL-1660 Guia De Instalacion

To power on the DFL-1660 device, press the
AC power switch on the rear panel to the on
position. To power off the device, press the
power switch to the off position.
Connecting the Device to a Network
This section provides basic information about
physically connecting the DFL-1660 to a
network. Follow the steps below to connect the
firewall as shown in Figure 7.
1. Connect an RJ-45 cable from the port
labeled 1 to the external router. The port
No. 1 is pre-allocated to the WAN1 network
segment.
2. Connect an RJ-45 cable from the port
labeled 3 to a switch in the DMZ network
segment.
3. Connect an RJ-45 cable from the port
labeled 4 to a switch in the LAN1 network
segment.
4. Connect an RS-232 cable from the console
port to a computer for CLI (Command Line
Interface) management access.
Internet
WAN1
DMZ
LAN1
Server
Farm
Figure 7. Basic Cabling Example

Initial Configuration

The NetDefendOS software is pre-installed
on the DFL-1660 device. When the device is
powered on, it is ready to be configured. While
the device has a default factory configuration
that allow you to initially connect to the device,
you must perform further configuration for your
specific network requirements.
Using the WebUI
To use the WebUI, the workstation from which
you are managing the device must initially be
on the same subnetwork as the device.
Browser
To access the device with the WebUI:
1.
2.
3.
Console
Users
Note: DFL-1660 allows either HTTP or a secure
HTTPS connections from any management
host. However, for security reasons, only
a secure HTTPS connection is allowed by
default. For more information about configuring
connections settings, please refer to the
Firewall User Manual.
Microsoft Internet
Explorer
Mozilla Firefox
Netscape Navigator 8.0 or higher
Table 5. Browser Compatibility
Use an Ethernet cable to connect your
workstation to the port labeled 4, which is
pre-allocated to LAN1.
Ensure your workstation is configured with
a static IP address in the 192.168.10.0/24
subnet.
Note: Disable pop-up blocking software
or add the management IP address
https://192.168.10.1 to your pop-up
blocker's allow list.
Launch your browser; enter the IP address
for the LAN1 interface, then press Enter.
(The factory default IP address is
https://192.168.10.1)
Figure 8. Browser Address
D-Link NetDefend Firewall  5
Version
6.0 or higher
1.0 or higher