Technical Specifications - ECG IV 18 Manual De Instrucciones

Warning code Possible cause
EO An unsuitable pot/pan is on the
induction zone or the diameter of the
pot/pan is less than 12 cm.
E1
Bad connection of the induction hob/
faulty electrical circuit.
E2 Problem with the temperature sensor. Contact an authorized service center.
E3 Voltage is too high.
E4
Voltage is too low.
E5
Protection against overheating – the
cooktop is too hot.
E6 Problem with the fan, the air intake/
outflow is blocked.

TECHNICAL SPECIFICATIONS

Ceramic glass cooktop
Quick heat-up time and energy saving
Minimal heat loss
Suitable for 12–24 cm diameter cookware
Extra large LED display
10-stage temperature control (60 °C – 240 °C)
10-stage power setting (200–1800 W)
1 to 180 minute timer
Touch control
Automatic safety cut-off after cookware is set aside
Overheating and surge protection
Power on indicator
Nominal voltage: 220–240 V~ 50/60 Hz
Nominal input power: 1800 W
Noise level: <40 dB
Solution
Place suitable cookware on the cooktop.
Contact an authorized service center.
Check the power source, turn on when the
power source returns to normal.
Check the power source, turn on when the
power source returns to normal.
Wait few minutes until the appliance cools;
check the pot/pan.
When the appliance cools down, clean the
openings. Afterwards, restart the appliance.
If the problem persists, contact an authorized
service center.
GB
47
47