Overtemperature Protection; Polymerization; Selecting The Temperature Stage; Timer Display - Kulzer Palamat elite Instrucciones De Uso

7.2.1

Overtemperature protection

The Palamat elite unit is equipped with two overtemperature protections which are activated if the temperature
is exceeded by 110°C (230°F).
In the event of activation of the fuses, the heating circuit is interrupted.
Please check your minimum filling level.
Note!
The overtemperature protections may only be reset by trained service personnel.
Contact your responsible service agent (see chapter 11 Service).
GB 7.3

Polymerization

To switch on the unit, press the power switch (5) at the front of the unit. The power switch is lit and indicates that the unit
- 8 -
has been started up. The software version is shown in the Timer Display (15) for a short period.
7.3.1

Selecting the temperature stage

The yellow LED indicates the currently selected temperature program.
The select-key is used for selecting prior to the polymerization process.
The select-key is deactivated during the process.
Additionally, the blinking pattern of the LED indicates the current temperature status.
Selection of
stage
45°C (113°F)
55°C (131°F)
100°C (212°F)
70°C – 100°C
(158°F – 212°F)
*) The Kulzer water bath features a fixed temperature ramp (see Kulzer materials):
➜
70°C (158°F)
7.3.2

Timer Display

The process time is set with the Timer plus / minus key (16).
Max. time is 9:59 h:m.
Once the process temperature is reached, the colon flashes, and the timer starts
to countdown the time in minutes. The timer can not be set during the countdown.
The remaining time is calculated and displayed by the internal processor based defined
time / temperature control for the Kulzer water bath.
The remaining time may vary depending on the filling level of water and quantity of flask
baskets in the polymerization pot.
If an error is detected, it is also displayed in the timer display. Error messages are indicated
by "E" (e.g. E 01). A table containing possible error messages can be found in chapter 10 (Information on malfunctions).
75% 25%
100%
75% 25%
Polymerization Standby
type temperature
Cold polymerization 45°C (113°F)
Cold polymerization 55°C (131°F)
Hot polymerization 100°C (212°F)
Hot polymerization 70°C (158°F)
(Kulzer water bath)
➜
residence time 90 min heating up to 100°C (212°F) within 30 min
Heating.
LED is deactivated shortly
Temperature is reached.
LED is permanently lit
Cooling down.
LED is activated shortly
Process Pressurization
temperature
45°C (113°F) automatic
55°C (131°F) automatic
100°C (212°F) manually
70°C – 100°C manually
(158°F – 212°F)
➜
Timer
freely editable
freely editable
freely editable
automatic preset *)
residence time 30 min.