Before You Begin - D-Link DAP-3520 Guia De Instalacion

Before You Begin

It's best to use a computer (with an Ethernet adapter) connected to a switch to configure
the DAP-3520. The default IP address for the DAP-3520 is 192.168.0.50 with a subnet
mask of 255.255.255.0 on the wired Ethernet side. You will need to assign your
computer a static IP address within the same range as the DAP-3520's IP address for
the purpose of configuring the DAP-3520. If you need assistance assigning a static
IP address to your network adapter, please refer to the manual on the CD-ROM.
Important Information
This product should ONLY be installed by an experienced installer who is familliar
with local building and safety codes and where ever applicable, is licensed by the
appropriate authorities. Failure to do so may void the D-Link product warranty and
may expose the end user or the service provider to legal and financial liabilities.
D-Link and its resellers or distributors are not liable for injury, damage, or violation
of regulations associated with the installation of outdoor units or antennas.
A safety grounding system is necessary to protect your outdoor installation from lightning
strikes and the build-up of static electricity. The grounding system must comply with the National
Electrical Code and safety standards that apply in your country. Always check with a qualified
electrician if you are in doubt as to whether your outdoor installation is properly grounded.
Note:
DAP-3520 is certified to IP65 which means the device is protected from dust and low pressure
jets of water from all directions - limited ingress permitted. It is recommended to place this device
under a roof.
3