Disinfecting The Whirlpool System; How Often; How; Sanitary-Grade Acrylic - DURAVIT Durapearl-System Manual De Instrucciones

6.1

Disinfecting the whirlpool system

How often?

Disinfect the whirlpool system before using it for the first time, and then after every
tenth bath, but at least one a month and after a long period of no use.

How?

CAUTION! Chlorine bleach irritates the skin.
> Observe the safety instructions on the disinfectant.
> Do NOT bathe in the whirlpool tub while disinfecting it.
> Ensure that the room is well-ventilated during the disinfection process.
> Fill the tub with water.
> Add the chlorine bleach to the water in accordance with the manufacturer's
instructions.
> Switch on the Durapearl jets.
> Allow the water in the tub to settle for 5 minutes.
> Switch on the Durapearl jets.
> Drain the water and rinse the tub.
> Fill the tub with water again.
> Switch on the Durapearl jets.
> Drain the water.
> Repeat the process as necessary.

6.2 Sanitary-grade acrylic

Cleaning

> Clean acrylic with a soft, damp cloth.
> Use the Duravit Maintenance Set for Acrylic Surfaces for the occasional thorough
cleaning and for removing stubborn spots.
> Remove extensive soiling with warm water and a liquid detergent, dish washer
liquid or soap suds.

Damage

> Remove scratches and other surface damage with the Duravit Acrylic Surface
Maintenance and Repair Set (Art. No. 790302 00 0 00 0000).
20

6.3 Controls

> Clean the controls with a soft, damp cloth.
6.4 Drain and overflow fittings
> Clean the drain and overflow fittings with a soft, damp cloth.
7.

Troubleshooting support

CAUTION!
The whirlpool tub may be repaired only by qualified plumbers and electricians.
Problem Potential cause
Foaming Soap or shampoo in
the bathwater.
The whirlpool system runs Water level too low.
only briefly?
Whirl system does not start? Mains switch switched off.
Mains fuse is switched off.
Ground-faultswitch (RCD) or
circuit breaker has tripped.
Buttons do not function Air in button after whirl
properly? system has been standing
idle.
Sound volume / quality Data not compatible.
cannot be changed.
Solution
>
Switch off the whirlpool
system.
>
Fill the tub with fresh
water.
>
Add water until the water
level is about 5 cm above
the intake cover.
>
Press "Durapearl" for a
while.
>
Switch on at mains.
>
Switch on mains circuit
breaker.
>
Disconnect tub from mains.
>
Call Customer Service.
>
Press button once again.
>
Check whether the audio
source supports the A2DP
protocol.
21