Transport And Storage; Cleaning And Maintenance - Grouw 18035 Manual De Instrucciones

Setting the maximum particle size
By adjusting the distance between the
baseplate and the air inlet, you can set the
maximum particle size to be drawn into the
submersible pump.
Remove the baseplate (d) and pull the rotary
disc (c) out. Turn the rotary disc to the left or
right to the required setting. See the arrow
(b) on the rotary disc (c).
a
The particle size can be seen on the air inlet
(a).
a
Always push the baseplate fully in once you
have fi nished using the submersible pump.
20
b c
d
Use
The pump can be set to automatically switch
on and off at specifi c water levels.
When adjusting the fl oat, it is essential to do
this in a location where it is easily accessible.
The pump can, for example, be placed in a
bowl of water. Position the fl oat in the holder.
Lift the fl oat to the maximum position, so the
pump begins to run. Lower the fl oat slowly
to the minimum position, until the pump
switches off . Remember to make sure that
the pump stops before the fl oat touches the
bottom; otherwise the pump will run dry and
could be damaged.
Check that the pump's connections fi t tightly.
Switch the pump on and off at the mains
socket.

Transport and storage

Lift the pump by the carrying handle when
transporting it.
Store the pump in a dry, frost-free location.
Clean the pump components with clean
water and allow them to dry completely
before storing.

Cleaning and maintenance

The pump is maintenance-free.
If you are using the pump as a permanent
installation, you should check the function
of the fl oating switch every three months.
Remove any deposits from the fl oat and
wash any mud, etc. off the pump's impeller.
If the impeller is clogged by dirt, you should
remove the intake from the pump and clean
the impeller with clean water. The pump
must not rest on the impeller. Reassemble
the pump before use.