DISPLAY BRACKET ASSEMBLY INSTRUCTIONS
Display Bracket Assembly
Note: Do not use display bracket for wall mount. Display bracket is for surface use only. For
wall mounting, mount display assembly directly to the wall, see page 8.
1. Carefully remove the scale platform with the display assembly from the carton, and place the
scale platform and display assembly on a flat, level, and dry surface.
2. Remove the display bracket from the carton.
3. Remove the two small screws from plate B.
4. While holding plate A, slide the tab of plate B up and under the center tab on the back of plate
A.
5. Align plate A and plate B, and ensure that the screw holes are lined up.
6. Insert the two small screws into the front of plate A and through the holes in plate B.
7. Using a Phillips head screwdriver, tighten the screws to secure plate A to plate B.
8. Slide the two mounting studs on the display bracket into the two mounting holes in the back
of the display assembly. The display bracket is now ready for use.
Plate A
Display Bracket
Screws
Tab
Plate B
7
Mounting studs
Center tab
Screw
holes