Descargar Imprimir esta página

Powering The Scale - Pelstar Health o meter 498KL Instrucciones De Uso

Publicidad

Idiomas disponibles

Idiomas disponibles

POWERING THE SCALE

Powering the Scale / Inserting Batteries
1. With a Phillips head screwdriver remove the battery cover on the side of the display
assembly by unscrewing the (2) battery cover screws (see drawing below).
2. Replace or install 6 new AA batteries. Health o meter Professional recommends using
alkaline or lithium batteries, rated for 130°F (54°C) operation. Do not use zinc-carbon
batteries.
3. Re-attach the battery cover to the display assembly.
4. Ensure all objects are removed from the scale's platform, and then press the ON/OFF button
to turn the scale on. The display will show "Start", then "0.0" LB or "0.0" KG. Press the
LB/KG button to select the weight mode (LB or KG).
Note: The battery icon on the display does not indicate battery life. The battery icon is displayed
when the scale is using batteries as the power source.
Note: This scale will always default to the settings and units last used (LB or KG).
Note: If the set up procedure fails, refer to the troubleshooting instructions. If the problem is not
corrected, contact Health o meter Professional Scales Customer Service at 1-800-815-6615.
Note: If "Lo" appears on the display, it indicates that the battery power is low. It does NOT
indicate a problem with the weight measurement.
Warning: If the scale will not be used for some time, remove the batteries to avoid a
safety hazard. Disposal of batteries must be performed in accordance with the prevailing
national, regional or local regulations that apply to
Optional AC Adapter
1. Connect the optional AC adapter (not included) into the adapter jack on the scale platform.
Warning: To avoid a safety hazard, use AC adapter model ADPT31 (USA and Canada) or
ADPT30WA (International, plug
2. Plug the scale's AC adapter into the power source.
3. When the AC adapter is disconnected from the scale, the scale will switch to battery power if
batteries are installed.
Caution: Always plug the AC adapter into the scale first, then into the power source/wall outlet.
BATTERY COVER
BATTERY
SCREW
Adapter Jack
kit).
you.
DISPLAY ASSEMBLY
9
Scale platform

Publicidad

Solución de problemas

loading