kayami S-10/20-M Manual Del Usuario página 22

Calor instantaneo
6
and the device will start operating in Ventilator Mode. If we press
the ON/OFF button when the device is operating, we will turn the
device OFF. Attention: when we turn the device OFF the ventilator
will continue working approximately 30 seconds until the hot of in-
side the device disappears (The ventilator mode will continue ON
this seconds).
- 1000W (Low Heater Mode). When you put the heater ON, this will
start operating in Ventilator Mode. If we press the 1000W button in
the control panel the light will turn on the corresponding light for it
and it will start operating in that mode. If we press 1000W button
again we will cancel the heater mode and the device will continue
working in Ventilator Mode.
- 2000W (High Heater Mode). Pressing the 2000W button the heater
will start operating in High Heater Mode and in the control panel will
switch ON the corresponding light. If we press the button once again,
we will cancel this function and it will start the Ventilator Mode.
- TIMER. UIT this button we can control that the device operates during
a fixed time and that when this time passes it stops operating au-
tomatically. Every time we press this button we will add 30 minutes
more to the timer, when you see how much lights are ON you could
see the total of minutes/tour you have set the timer.
2.- Control panel
Using the two buttons settled in the control panel of the device you
can make the same choices of functions as in the remote control.
ON/OFF Button Mode (ON/OFF and Operating Modes):
1. With the device OFF, press ON/OFF button once and the device
will start operating in Ventilador Mode. The light will tunr ON in the
control panel.
2. Press the button a second time and the device will start operating
in Low Heater Mode (1000W). The corresponding light will turn ON in
the control panel.
3. Press the button a third time and the device will start working un
High Heater Mode (2000W). the corresponding light will turn ON in the
control panel.
4. When you press the ON/OFF button a fourth time the heater will
turn OFF and the ventilador will continue operating more or less 30
seconds until the device gets cold.
TIMER Button:
Taking the device ON, press the TMER button to make the device
work a determinate time and after that time it switches OFF automati-
cally. Each time we press this button we will choose 30 minutes more
until reaching 7,5 hours of timer. The time of the programation will be
measured with the lights that are ON.