Initial Use - Stanley TM201 Manual De Usuario

Timer pins are factory preset in the
"pushed down" ('ON') position.
Pull pins up for timers 'OFF' intervals.

INITIAL USE:

Install the cord and unit at least 5ft (1.5m) above
ground level with the outlet receptacle facing
downward. Let the switch hang downward so
moisture doesn't accumulate in the outlet. Plug the
lights or appliances into the outlets at the bottom.
OPERATING INSTRUCTIONS
1 - Locate the electrical outlet that is close to the
device you want to control.
2 - Set the ON / TIMER switch located next
to the dial to the TIMER position. Plug the
timer into the outlet.
3 - Set the current time - turning clockwise,
align the Arrowhead (See diagram) on TOP
AM
Pins
Down=ON
Up=OFF
4 - Determine desired start time and push "DOWN"
all pins until desired OFF time. When pins are pushed
down the timer will be on and working. When pins are
in the UP position timer is OFF (note: "pins" are grey
of the timer to the
present time (lines
between numbers
ON
are in increments of 30 minutes).
There is no need to touch the
TIMER pins to set current time. NOTE:
Dial is based on AM/PM.
AM
Pins
Down=ON
Up=OFF
ON
TIMER