Cleaning And Maintenance; Cleaning The Trimmer - ViSAGE 95597 Manual Del Usuario

1. Switch off the trimmer.
2. Turn any previously used attachment counterclockwise
(bayonet catch) to remove it from the trimmer.
3. Align the eyebrow/beard attachment so that it can
be slotted into the bayonet catch. Twist clockwise to
secure the eyebrow/beard attachment (see Fig. I).
4. Position the trimmer on the area at a right angle and
slowly pull downwards. Repeat till desired trim
is achieved.
5. After use, slide the protective cap
downwards to be fully attached.
Attaching a guide comb
1. Make sure the trimmer is switched off and remove
the protective cap
2. Align the guide comb
the eyebrow/beard attachment (see Fig. J).
3. Change the guide comb direction to adjust the
trimming length between 3 mm (0.12 inch) and 6 mm
(0.24 inch).

Cleaning and maintenance

Cleaning the trimmer

1. Make sure the trimmer is switched off.
2. Remove any attachment.
3. Use a soft, damp cloth to wipe off the trimmer.
4. Make sure all components are thoroughly dry before
attaching the protective caps
Cleaning and maintenance
9 .
5 so that it can be slotted onto
9
from the top
9
/ and storing.
10
19