Instructions Before Installation - Dometic Heki 3 Plus Instrucciones De Montaje Y De Uso

Heki 3 Plus
6

Instructions before installation

➤ Before installation, check the roof thickness of your vehicle. Consult the
vehicle manufacturer if you have any questions.
➤ Make sure that the power supply line and a switch are available for the
Heki 3 Plus (12 V, 2 x 8 W) lighting in the vehicle.
➤ Make sure that the power supply line is suitably arranged and protected.
➤ When choosing the installation location, observe the following:
– Adjoining components (roof rack or attachment and reinforcing parts),
cables and cabinets in the vehicle interior must not get damaged when
sawing the hole.
– Sufficient space needs to be available for installing the inner and outer
frames.
– Only fit the roof light on flat and parallel interior and exterior roof areas
with a maximum inclination of 15° to the horizontal.
– You may use an existing roof hole provided the roof light fits into it.
– You can fit the roof light sideways (hinge-side at front in direction of
travel) or lengthways (hinge-side on left or right in direction of travel).
6.1 Pressing out the hole
See fig. 2
6.2 Using the reinforcing rails
Supplementary to fig. 3
➤ Before installation, check whether the roof hole needs reinforcing.
➤ Remove the foam according to the width of your reinforcing rail (not in
scope of delivery) (A).
➤ Fit the reinforcing rails (B).
EN
Instructions before installation
17