Prest-O-Lite PT-31XL Manual Del Usuario página 7

sectioN 1
5. WarNiNg: this product, when used for welding
or cutting, produces fumes or gases
which contain chemicals known to
the state of california to cause birth
defects and, in some cases, cancer.
(california health & safety code
§25249.5 et seq.)
cYliNDer haNDliNg -- cylinders,
if mishandled, can rupture and vio-
lently release gas. sudden rupture
of cylinder, valve, or relief device can
injure or kill. therefore:
1. Use the proper gas for the process and use the
proper pressure reducing regulator designed to
operate from the compressed gas cylinder. Do not
use adaptors. Maintain hoses and fittings in good
condition. Follow manufacturer's operating instruc-
tions for mounting regulator to a compressed gas
cylinder.
. Always secure cylinders in an upright position by
chain or strap to suitable hand trucks, undercar-
riages, benches, walls, post, or racks. Never secure
cylinders to work tables or fixtures where they may
become part of an electrical circuit.
. When not in use, keep cylinder valves closed. Have
valve protection cap in place if regulator is not con-
nected. Secure and move cylinders by using suitable
hand trucks. Avoid rough handling of cylinders.
4. Locate cylinders away from heat, sparks, and flames.
Never strike an arc on a cylinder.
5. For additional information, refer to CGA Standard P-1,
"Precautions for Safe Handling of Compressed Gases
in Cylinders", which is available from Compressed
Gas Association, 15 Jefferson Davis Highway,
Arlington, VA 0.
eQuipmeNt maiNteNaNce -- Faulty or
improperly maintained equipment can
cause injury or death. therefore:
saFetY precautioNs
1. Always have qualified personnel perform the instal-
lation, troubleshooting, and maintenance work.
Do not perform any electrical work unless you are
qualified to perform such work.
. Before performing any maintenance work inside a
power source, disconnect the power source from
the incoming electrical power.
. Maintain cables, grounding wire, connections, power
cord, and power supply in safe working order. Do
not operate any equipment in faulty condition.
4. Do not abuse any equipment or accessories. Keep
equipment away from heat sources such as furnaces,
wet conditions such as water puddles, oil or grease,
corrosive atmospheres and inclement weather.
5. Keep all safety devices and cabinet covers in position
and in good repair.
6. Use equipment only for its intended purpose. Do
not modify it in any manner.
aDDitioNal saFetY iNFormatioN -- For
more information on safe practices for
electric arc welding and cutting equip-
ment, ask your supplier for a copy of
"precautions and safe practices for arc
Welding, cutting and gouging", Form
52-529.
The following publications, which are available from
the American Welding Society, 550 N.W. LeJuene Road,
Miami, FL 16, are recommended to you:
1. ANSI/ASC Z49.1 - "Safety in Welding and Cutting"
. AWS C5.1 - "Recommended Practices for Plasma Arc
Welding"
. AWS C5. - "Recommended Practices for Plasma Arc
Cutting"
4. AWS C5. - "Recommended Practices for Air Carbon
Arc Gouging and Cutting"
7