Danby Designer DWC114BLSDD Manual Del Propietário página 5

INSTALLATION INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the screw covers and screws from the
hinge cover. Remove the hinge cover.
2. Remove the screws from the upper hinge.
Remove the upper hinge. Remove the door from
the cabinet.
3. Remove three screw hole covers from the top left
side of the cabinet and place them in the screw
holes on the top right side of the cabinet where
the upper hinge was.
4. Remove the screws from the lower hinge and the
adjustable foot. Swap the positions of the lower
hinge and the foot and reinstall.
5. Remove two screws securing the actuator and
remove it from the door. Install the actuator at
the top of the door frame. Screw holes can be
found at the top of the door by gently pulling
back the rubber gasket. When reinstalling the
door on the cabinet, it will need to be fl ipped
180° from its original position to ensure that
the handle is on the correct side and that the
actuator is on the bottom. Install the door on the
lower hinge before reinstalling the upper hinge.
Ensure the top of the door is properly aligned
with the top of the cabinet, that the actuator is
making contact with the switch on the cabinet
and that the rubber gasket makes a good seal
with the cabinet all the way around.
6. Install the upper hinge and hinge cover on the
top left of the cabinet.
1. Screw cover
2. Screws
3. Hinge cover
4. Upper hinge
5. Screw hole covers
6. Lower hinge
7. Adjustable foot
8. Actuator
1
2
3
4
5
6
4
4
1
2
3
2
4
5
6
2
7
2
8