Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
10
installation B-type adapter
-
For taps with an aerator (threaded on the outside) (Fig. 7).
1
Remove the attachment nut and the adapter from the water
purifier (Fig. 8).
Remove the aerator cap from the tap and pass the attachment nut
over the spout. Take out the original adapter and screw the
matching adapter (B-type) onto the tap (Fig. 9).
Tighten the adapter further with a coin (Fig. 10).
Firmly screw the attachment nut onto the water purifier
housing (Fig. 11).
installation C-type adapter
-
For taps with an aerator (threaded on the inside) (Fig. 12).
1
Remove the attachment nut and the adapter from the water
purifier housing (Fig. 13).
Remove the aerator cap from the tap. Take out the original adapter
and screw the matching adapter (C-type) onto the tap through the
attachment nut. If water leakage occurs, wind Teflon tape round the
screw thread of the adapter before you screw it onto the
tap. (Fig. 14)
Tighten the adapter further with a coin (Fig. 15).
Firmly screw the attachment nut onto the water purifier
housing (Fig. 16).
installation D-type adapter
-
For taps other than A, B or C. (Fig. 17)
1
Remove the attachment nut and the adapter from the water
purifier housing (Fig. 18).
Screw the D-type adapter about halfway onto the water selection
unit. Make sure to leave enough room in order to tighten the fitting
at a later step. (Fig. 19)
Publicidad
Tabla de contenido
