3- Main Menu; Analyser; Copy Emitter; Fixed Code - JMA CTM-700 Manual De Instrucciones

3
Main menu
When the machine is connected in 'Normal
Mode', the 'ANALYZE EMITTER' main menu
will appear.
Access the different menu options using the
'Up / Down' cursor keys.
AUTOMATIC CODE
EMITTER ANALYSER

COPY EMITTER

EMITTER POWER
FREQUENCY METRE
SIGNAL LEVEL
VOLT METRE
SAVE ADJUSTED
FREQUENCY CODE
To access the menu option shown on the
screen, press the 'Enter OK' key.
To return to the main menu, press the
'Escape' key.
3.1 Emitter analyser
To identify the emitter specifications and to
make a copy, select the 'EMITTER ANALYSER'
menu option by pressing the 'Enter OK' key.
Place the emitter in the scan area and acti-
vate transmission. You will see '...WAITING'
appear on the screen.
The machine carries out a large number of
verifications because it needs to distinguish
between large numbers of control models.
For this reason it will not stop until some-
thing appears on the screen or it is retur-
ned to the 'EMITTER ANALYSER' mode. En
ocasiones la máquina puede emitir un pitido
continuo cuando la lectura ha sido errónea.
En este caso, es suficiente con volver a pulsar
enter para realizar una nueva lectura.
The type of emitter will appear on the screen,
binary, trinary, binary2, multifrequency, etc.
In the case that there is a coder, the position
will be shown and if it is not the evolution
type, the message 'Rolling Code' will be
shown next to the emitter screen.
Once the analysis scan has been made, the
code will remain in the memory mode so
that any control can be copied or verified
selecting the options in the main menu.
Once analysed and with the code saved in
the memory, exit to the main menu pushing
the 'Escape' key.
Copy emitter
3.2
3.2.1 Open 'Fixed Code' emitters
Once the original emitter has been analysed,
it can be copied using the copy process in the
'Copy Emitter' menu.
Connect the recording cable to the machine
with the white connector and in the copy
control.
NOTE: The emitter being analysed must have
a battery in it.
1. Select a destination emitter channel on
which to make a copy by pressing the
corresponding number on the keyboard.
When it appears on the screen, press
'Enter OK' to accept.
13 13