Evolutive Code - JMA CTM-700 Manual De Instrucciones

2. If 'Copy Correct' appears, the process has
satisfactorily completed.
In the case that the message 'Copy Error'
appears, repeat the process by analysing
the original emitter again.
3. To adjust the frequency, select the
'Frecuencymetre' option from the menu.
Here, the frequency of the copied emitter
can be read and compared with the ori-
ginal emitter.
3.2.2 Evolutive Code' emitters
If the evolutive control analysed previously
in the option "ANALYZE EMITTER" was from
the first generation, when copy emitter is
pressed, connect the control with the cable
for evolutive programming and validate the
copy option.
If the control is not the first generation, the
copy will not be made directly and the origi-
nal control manufacturer must be selected.
The following table shows the manufacturer
number for each type.
14
TYPE WHERE MANUFACTURER
IS NOT DIRECTLY DETECTED
1. MUTANCODE
2. ERREKA
3. ROPER
4. BFT
5. PUJOL
6. NORTON
MANUFACTURERS
DETECTED DIRECTLY
FIRST GENERATION JCM INCLUDING
TOBACCO MACHINES
GIBIDI
DEA
NICE SMILO
CELINSA
DOORMATIC
Once the number of the manufacturer has
been selected, go directly to the control copy. In
the first software version, the channels in each
button are automatically configured depending
on the manufacturer. In future versions the
channels may be configured manually so that
a copy can be made and the buttons configu-
red as desired. This option will allow different
manufactures use different push button con-
trols. To know the configuration of the push
buttons required, look at the first digit that
shows in the "ANALYZE EMITTER" option when