Clore Automotive Jump-N-Carry JNC311 Manual Del Usario página 5

The Jump-N-Carry features a power status button and LCD display the unit's state
of charge.
The Jump-N-Carry features a variety of safety features, including reverse polarity
protection, backfeed protection, short circuit protection, over voltage protection and
under voltage protection.
UNIT STATUS AND RECHARGING PROCEDURES
Note: Upon initial purchase, your Jump Starter should be charged for a minimum of 6
hours. The Jump Starter should be charged every three months when not in use.
Unit Status Indication
Press the Status/Power Button on the front of the unit to power the display and see
the unit's state of charge. The unit's state of charge status is indicated by a graphical
representation of a battery as well as a percent of charge value (e.g. 95%).
– If the unit has below 70% state of charge, it should be charged soon.
– If the unit has below 50% state of charge, it should be charged immediately.
It is recommended that the unit be at or near 100% state of charge when using as a
jump starter. This will greatly improve your jump starting success.
Recharging Your Jump Starter
WARNING: Never use a charger other than the one that was included with your unit.
Using an incompatible charger could damage the internal battery, which could result in
property damage or injury.
1. Connect the pin jack at the end of the included AC adapter cord to the jump
starter through the input port marked "DC Input."
2. Connect the male end of the AC adapter to the AC outlet.
3. Using this method, the unit will be brought to full charge automatically without
overcharging.
5