Schwinn Fitness 460 Instrucciones Para El Montaje página 10

Step 5: Swing Arms and Handlebars
Parts
• Assembly from Step 4
• #5 - Right Handlebar (Qty 1)
• #6 - Left Handlebar (Qty 1)
• #10 - Right Swing Arm (Qty 1)
• #11 - Left Swing Arm (Qty 1)
Hardware
• #21 - Round Cover (Qty 2)
• #24 - M8 x 20 Button Head Bolt (Qty 8))
• #25 - M8 x 20 Hex Head Bolt (Qty 2))
• #27 - M8 Spring Lock Washer (Qty 10)
• #28 - M8 Flat Washer (Qty 8)
• #29 - M8 Wide Flat Washer (Qty 2))
• #33 - Wave Washer (Qty 2)
Assembly
Tools
• 6mm Hex Key
• Combination Wrench (Qty 2)
Note: Perform steps 5-1 and 5-2 on one side and then repeat
on the other side.
5-1 Put one Wave Washer on the Arm Pivot Rod (22) on the
right side (Figure 5a).
5-2 Install the Right Swing Arm on the Arm Pivot Rod with
one M8 Wide Flat Washer, M8 Spring Lock Washer
and M8 x 20 Hex Head Bolt (Figure 5a).
5-3 Tighten the hardware on the Swing Arms. Install the Round
Covers (Figure 5a).
(Step 5 continued on next page)
11
Figure 5a
8
Assembly Manual
22
10
33
29
27
25
21