Antenna Connection; Speaker Connection - Sharp CD-MPX870 Manual De Manejo

Antenna connection

Supplied FM antenna:
Connect the FM antenna wire to the
FM 75 OHMS jack and position the FM
antenna wire in the direction where the
strongest signal can be received.
Supplied AM loop antenna:
Connect the AM loop antenna to the
AM and GND terminals. Position the
AM loop antenna for optimum
reception. Place the AM loop antenna
on a shelf, etc., or attach it to a stand
or a wall with screws (not supplied).
Note:
Placing the antenna on the unit or near the AC power cord may
cause noise pickup. Place the antenna away from the unit for better
reception.
Installing the AM loop antenna:
< Assembling > < Attaching to the wall >
Wall

Speaker connection

Connect the black wire to the FRONT SPEAKERS minus (-) terminal,
and the red wire to the FRONT SPEAKERS plus (+) terminal.
Speaker Light-Up connection
Connect the speaker light-up wires to the SPEAKERS LIGHT-UP
jacks for speaker illumination. To turn off the speaker light-up fea-
AM loop
FM
ture, press the CLEAR/DIMMER button on the remote control for 2
antenna antenna
seconds or more.
ANTENNA
FM
GND AM
75 OHMS
Note:
Placing the right speaker light-up wire to the RIGHT jack and the left
speaker light-up wire to the LEFT jack.
Caution:
Use speakers with an impedance of 6 ohms
or more, as lower impedance speakers can
damage the unit.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Screws (not supplied)
Do not let the bare speaker wires touch
each other.
Do not stand or sit on the speakers. You may
be injured.
Do not allow any objects to fall into or to be
Red
placed in the bass reflex duct.
Black
03/12/17
LEFT SPEAKER RIGHT SPEAKER
Incorrect
CD-MPX870 01-13.fm
CD-MPX870
CD-MPX870W
ENGLISH
E-10