Eq Profiles; Signal Sensing - Silver W-12 Manual Del Usario

EQ Profiles

The Silver W-12 has 3 preset EQ profiles. These are EQ1 (Movies), EQ2 (Music) and EQ3
(Impact).
These profiles change the characteristics of the sound from the subwoofer. We highly
recommend experimenting with the different profiles to see which most suits your room,
tastes, environment, etc. An example of the different profiles do can be seen below:
10
8
6
4
2
0
-2
-4
-6
-8
-10
Additional Information for Auto On/ Off and Signal Sensing
In auto power mode, the method which wakes the system up takes priority until it is put
into standby, with trigger always taking priority over signal sensing.
Signal sense is around 1mV sensitive on both the stereo and LFE inputs.
Some examples can be seen below:
1. The system is woken up with signal. When the signal is stopped, a 20 minute timer
will start counting down to zero. At zero, the system will enter standby again. If a
signal is re-introduced within this 20 minute window, the system will reset and stop
the timer. The trigger line will not have any effect.
2. The system is woken up with the 12V trigger going high. The signal sense will not
affect the state of the amplifier. The amplifier will automatically enter standby when
the 12V trigger line transitions low.
3. The system is woken up with both signal present and the 12V trigger high. Trigger
will take the priority, and signal sense will not have any effect.
Silver W12 EQ Profiles
Music Movie
20 30
Impact
40 50 60
Frequency [Hz]
10
70 80 90 100