Silver W-12 Manual Del Usario página 7

7. RCA Line Level Outputs (Stereo Left & Right)
To be used to feed additional sub-woofers to the W-12 by 'daisy chain' type
connection. The outputs are link out only connections and do not provide any form
of filtering.
8. LFE Input (RCA Type)
This input is to be used when connecting the W-12 to an AV amplifier/ receiver. When
using the LFE input, the crossover control is not used. This is due to the crossover
function being controlled and set by the AV amplifier/ processor when it's set up
procedure is run.
9. LFE Output/ Link (RCA Type)
To be used to feed additional sub-woofers to the W-12 by 'daisy chain' type
connection. The output is a link out only connection and does not provide any form
of filtering.
10. Mains Power Switch
The Mains Power Switch should be switched to the 'Off' position when the Silver
W-12 will not be used for extended periods. The switch must be in the 'On' position
for the subwoofer to function.
WARNING: Due to the mains switch being located on the rear panel, the apparatus
must be located in the open area with no obstructions to access the mains switch.
11. IEC Mains Power Connector/ Fuse Location
The Silver W-12 is supplied with a two-pin mains input socket for connection to the
mains supply. Use ONLY the appropriate IEC mains lead provided with the product.
Also fitted is an external mains fuse. If a fuse blows during operation a spare fuse is
provided within the fuse holder for replacement. If you wish to change the fuse, you
can do this by removing the IEC mains lead and carefully levering out the original fuse
from its holder below the IEC mains input socket (11a). If the fuse blows again it is
advisable to seek help from an authorised service agent. DO NOT attempt to re-fit a
further fuse as this could result in serious damage to the amplifier unit.
5