Power Tool Safety - Promaker PRO-SD480 Manual Del Usuario

This tool is wired at the factory
for 120V AC operation. It must
be connected to a 120V AC, 15 A
circuit that is protected by a time-
delayed fuse or circuit breaker. To
avoid shock or fire, replace power
cord immediately if it is worn, cut or
damaged in any way.

POWER TOOL SAFETY

WARNING: Read all safety
warnings and instructions. Failure
to follow the
instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions
for future reference.
Work area safety
Keep work area clean and well
lit. Cluttered or dark areas invite
accidents.
Do not operate power tools in
explosive atmospheres,
as in the presence of flammable
liquids, gases or dust. Power tools
create sparks which may ignite the
dust or fumes.
Keep children and bystanders
away while operating a power
tool. Distractions can cause you to
lose control.
Electrical safety
Power tool plugs must match the
warnings and
such
outlet. Never modify the plug in
any way. Do not use any adapter
plugs with earthed (grounded)
power tools. Unmodified plugs and
matching outlets will reduce risk of
electric shock.
Avoid body contact with earthed
or grounded surfaces such as
pipes, radiators,
refrigerators. There is an increased
risk of electric shock if your body is
earthed or grounded.
Do not expose power tools to rain
or wet conditions. Water entering
a power tool will increase the risk of
electric shock.
Do not abuse the cord. Never use
the cord for carrying, pulling or
unplugging the power tool. Keep
cord away from heat, oil, sharp
edges or moving parts. Damaged
or entangled cords increase the risk
of electric shock.
When operating a power tool
outdoors, use an extension cord
suitable for outdoor use. Use
of a cord suitable for outdoor use
reduces the risk of electric.
If operating a power tool in a
damp location is unavoidable, use
a residual current device (RCD)
protected supply. Use of a ground
fault circuit
reduces the risk of electric shock.
ranges
interrupter (GFCI)
and
3