Installation And Connection; Remedy Of Faults; Maintenance And Cleaning - Oase InScenio Instrucciones De Uso

- EN -

Installation and connection

This is how to connect the power supply:
• Insert the speed controller into the socket.
• Observe the specified safety distance of the unit from the water (B).
• Insert the plug of the pump connection cable into the speed controller.
Operation
How to operate the unit:
1
2
Switching the pump on and off
Press the button
once briefly:
Controlling the pump (the pump is switched on)
Press and hold the
button down:
Release the button:
Press and hold the
button down again:

Remedy of faults

Malfunction
Unit does not react to actuation of buttons

Maintenance and cleaning

W A R N I N G
Possible death or severe injury from hazardous electrical voltage!
• Prior to reaching into the water, isolate (switch off and disconnect) all units/devices used in the water.
• Isolate the device (disconnect from the power supply) before carrying out any work on it.
Cleaning the unit
Clean the unit with a soft, clean and dry cloth. Never use aggressive cleaning agents or chemical solutions. These can
attach the housing surface or impair the function.
Disposal
N O T E
Do not dispose of this unit with domestic waste.
• Render the unit unusable beforehand by cutting the cables and dispose of the unit via the return system
provided for this purpose.
8
Button for switching the pump on and off, and for controlling it.
Status LED. The LED is lit when the unit is supplied with mains voltage.
Pump is switched on or off.
– When the pump is switched on, it is controlled at the most recently
saved speed value.
– The current speed value is saved when the pump is switched off.
The speed value changes continuously. The fountain height/flow quan-
tity changes accordingly.
The current speed value is set/fixed.
The counting direction is changed and the speed value changes contin-
uously.
Cause
Unit defective
Mains voltage switched off
Connected pump is not working
Remedy
Replace unit
Switch on mains voltage
Read the pump operating instructions.
Connect the pump directly and check its
function