Tabla De Contenido; Description; Safety; Purpose Of This Manual - Greenlee GATOR LS50L2 Manual Operación

Table of Contents
Description ..................................................................... 2
Safety ............................................................................. 2
Purpose of this Manual .................................................. 2
Important Safety Information ..................................... 3-5
Identification ................................................................... 6
Specifications ................................................................. 6
Setup and Operation ................................................ 7-12
Capacity and Draw Stud Selection Guide .................... 13
Maintenance ................................................................. 14
Troubleshooting ............................................................ 15
All specifications are nominal and may change as design
improvements occur. Greenlee Textron Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
GATOR, Kwik-Stepper, Slug-Buster, and Slug-Splitter are registered
trademarks of Textron Innovations Inc.
Greenlee / A Textron Company
LS50L2 Battery-powered Punch Driver

Description

The Greenlee LS50L2 Battery-powered Punch Driver is
a hand-held, self-contained punch driver intended to be
used with Greenlee punches, dies, and draw studs for
punching holes through plastic, fiberglass, aluminum,
and steel.
The LS50L2 is designed to be used with the following
Greenlee accessories:
• Standard punches, dies, and draw studs
• Slug-Buster
• Slug-Splitter
• Electronic connector panel punches
• Special shape punches, dies, and draw studs
("D", Double "D", Key, Square, Rectangular, and
Oiltight with notches)
Standard, Slug-Buster, Electronic Connector Panel
Punches, and special shape punches can punch holes
through plastic, fiberglass, aluminum, and steel.
Slug-Splitter punches, dies, and draw studs are capable
of punching through all of these materials as well as
stainless steel. Refer to the "Capacity and Draw Stud
Selection Guide" in this manual for detailed information
on punch sizes and maximum material thickness.
Do not exceed the capacity of the punch.
This tool is protected by U.S. Patent No. 6,276,186,
6,401,515, 7,086,979, and 7,254,982 and patents
pending.

Safety

Safety is essential in the use and maintenance of
Greenlee tools and equipment. This manual and any
markings on the tool provide information for avoiding
hazards and unsafe practices related to the use of this
tool. Observe all of the safety information provided.

Purpose of this Manual

This manual is intended to familiarize all personnel with
the safe operation and maintenance procedures for the
following Greenlee tool:
Keep this manual available to all personnel.
Replacement manuals are available upon request at
no charge at www.greenlee.com.
KEEP THIS MANUAL
2
punches, dies, and draw studs
®
punches, dies, and draw studs
®
LS50L2 Battery-powered Punch Driver
Do not discard this product or throw away!
For recycling information, go to www.greenlee.com.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070