Axor Starck X 10070000 Manual Del Usuario página 8

Attention! The fitting must be installed, flushed and
tested after the valid norms.
Assembly
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slide the fixation piece including the washer
over the threaded pins and tighten the nuts.
4. Connect the connecting hose / supply pipes to
the isolation valves; cold right - hot left.
5. 10070000, 10072000, 10205000:
Connect the pull rod to the pop-up waste.
For a perfect waterfall (see page 15)
1. Dismount the spray former.
2. Check the filter and clean if required.
3. Mount the spray former.
The hot and cold supplies must be of equal
pressures.
Technical Data
T h i s m i x e r s e r i e s - p r o d u c e d
waterdimmer (flow limiter)
®
Rate of flow with waterdimmer:
Rate of flow without waterdimmer: 14 l/min 0,3 MPa
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temperature: 65° C
Test certificates
10070000/10071000/
10080000/10084000:
Operation
open
8
English
w i t h
5 l/min 0,3 MPa
max. 1 MPa
1,6 MPa
max. 80° C
WRAS
cold
close
Hansgrohe single lever mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
If the continuous water heater causes any problems or
there is not enough flow of water, the waterdimmer
(2a) located behind the aerator must be removed.
Spare parts (see page 4)
1 spout
2 spray former cpl.
3 spray former cpl. for bidet
4 handle
5 nut
6 cartridge cpl.
7 pop up rod
8 connection hose 10070000/
10072000/10077000/10205000 96321000
connection hose 10071000/
10080000/10084000
9 fixing set
10 extension hose300 mm
11 lever arm cpl.
12 supply pipe
13 aerator cpl.
Special accessories
X special tool set
(order as an extra)
97461000
97462000
97463000
10092000
97464000
96339000
97158000
96316000
13961000
13098000
96324000
96638000
98610000
58085000
hot
®